OpenAccess Exit button/relay

This has to do with the exit button/relay.  I call these functions from elsewhere, but basically it sets the timeout for activating the exit relay.  I also use this as a timeout to enter commands to the system (enter or leave modes, like adding users)

//exit button stuff
const int exit_button = 48; //digital pin the exit button is attached to
const int exit_relay = 0; //relay the door solenoid is on
const unsigned long exit_time = 3000; //time to keep the door open in thousandths of a second
boolean exiting = 0; //whether or not the door should be open (and timer running)
unsigned long exit_start_time = 0; //used for count down timer

That is the initialization; sets the button, relay, timeout, and two variables so it can let the rest of the code execute while it’s open.

void exit()
{
logging(logDate());
logging(” – “);
loggingln(“exit relay open”);
exiting = 1;
exit_start_time = current_time;
digitalWrite(relaysToPins[exit_relay], HIGH);
}

That starts the ‘exiting’ procedure, starts the timer rolling and opens the door.

void exit_timeout()
{
logging(logDate());
logging(” – “);
loggingln(“exit relay closed”);
LCD_default();
RFID_reset();
exiting = 0; //no longer in exiting mode
//exit_start_time = 0; //not needed
digitalWrite(relaysToPins[exit_relay], LOW); //close door
}

That stops the exit procedure, pretty simple really.

if (!digitalRead(exit_button)) //exit button pressed
{
//Serial.println(“exiting”);
exit();
}
//Serial.println(“past exiting”);

That checks to see if the exit button was pressed, and starts the exit procedure.

if (exiting)
{
if (current_time – exit_start_time > exit_time) //exit time out loop
{
exit_timeout();
}
}

That checks to see if the door should be re-locked (you can of course extend the timer with more code that backs up the start time to cheat this check)

That’s all there is to the exit button and exit relay code.  It can also be called like any other relay from the I/O section, but it operates on its own unlike the others.  This is part of the OpenAccess project.

Advertisements

One Response to “OpenAccess Exit button/relay”

  1. OpenAccess 3.0 replacement software | Evan's Techie-Blog Says:

    […] Exit button/relay […]

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s


%d bloggers like this: